Ticker Tutorial for tickerfactory.com

Step 1: You will go to tickerfactory.com. You can click on my ticker on the right side of the screen. Choose your design and enter your numbers. After your numbers are entered, click next.

Step 2: You should now see your completed ticker. On the bottom of the page, you will see two different ticker codes. Select and copy the bbcode, NOT the HTML.

Step 3: A close up of the bbCode.

Step 4: At lapbandtalk.com, go to your profile. You can access this by clicking on your name/picture on the upper right side of the screen. Click on my profile or my settings, and then select "edit profile."

Step 5: You will now see the general account settings. On the left hand side, select "Signature."

Step 6: Paste the bbCode from ticker factory into the edit signature section (highlighted in yellow). When you've successfully pasted, click "Save Changes" at the bottom of the screen. When the changes are saved, your ticker will appear as a preview under the "Your Current Signature." If it does not appear, go through the steps again to make sure you did as required. Also, check that you chose bbCode and NOT HTML.